Commission: new harmonised standards for medical devices — EN ISO 11137-1:2026 (radiation sterilization) and EN ISO 14155:2026 replace the old editions from 10 May 2028, listed for the first time include EN ISO 10993-7:2026 (ethylene oxide residuals), EN ISO 4074:2026 and EN ISO 15883-6:2026
The Official Journal of the EU of 10 November 2026 published Commission Implementing Decision (EU) 2026/2479. It amends the list of harmonised standards for Regulation (EU) 2017/745 on medical devices: two standards receive new editions and seven standards are added to the list for the first time. Devices in conformity with the listed standards are presumed to conform to the requirements of the Regulation covered by those standards.
- The decision amends the Annex to Implementing Decision (EU) 2021/1182, which lists the references of harmonised standards for medical devices drafted in support of Regulation (EU) 2017/745. Under Article 8(1) of that Regulation, devices in conformity with these standards are presumed to conform to the requirements covered by them.
- Replacing standards: entry 3a — EN ISO 11137-1:2026 “Sterilization of health care products – Radiation – Part 1: Requirements for the development, validation and routine control of a sterilization process for medical devices” (ISO 11137-1:2025) instead of EN ISO 11137-1:2015 with amendment A2:2019; entry 39a — EN ISO 14155:2026 “Clinical investigation of medical devices for human subjects – Good clinical practice” instead of EN ISO 14155:2020 with amendment A11:2024.
- The deletion of entries 3 and 39, i.e. the old editions, applies from 10 May 2028. The Commission deferred the withdrawal to give manufacturers sufficient time to adapt their processes and devices.
- Entries 66–72, added for the first time: EN ISO 4074:2026 (natural rubber latex male condoms – requirements and test methods), EN ISO 10993-6:2026 (tests for local effects after implantation), EN ISO 10993-7:2026 (ethylene oxide sterilization residuals), EN ISO 15883-6:2026 (washer-disinfectors employing thermal disinfection for non-critical medical devices and health care equipment), EN IEC 60601-2-22:2020 with amendment A11:2026 (laser equipment), EN IEC 60601-2-57:2026 with amendment A11:2026 (non-laser light source equipment) and EN ISO 80369-1:2026 (small-bore connectors for liquids and gases – general requirements).
- The decision entered into force on the day of its publication, 10 November 2026 — from that day, compliance with the new standards confers a presumption of conformity.
- For a laboratory testing medical devices — e.g. ethylene oxide residuals, condoms, washer-disinfectors or the radiation sterilization process — it is worth checking which edition of the standard the scope of accreditation and the test procedure refer to. The decision does not describe the technical changes between the editions.